Liteon Reading key

[hopper]

Hi All can someone help here

I cut the tracks on my drive point A and B when I meter the two points when the pogo goes i get a tone is this correct

i then run jungles flasher after i turn on my ck3 btw it what setting should i set on the ck3 for reading, jungleflasher will not detect the drive but when i use dos flash32 sometimes i get 0.72 and then remove the ground but when i click read i get unknown flash chip any ideas on this thanks

[blakey8]

Read the JungleFlasher tutorial, it explains what to do if you get "Unknown" flash status. It does say that you should NOT power down the drive though.

[Slick]

You should have gone for the new LT switch >> http://www.ck3.co.uk/xecuter-lt-switch.html it looks so simple

[blakey8]

Yes but although it is simple to install, you still need to cut a couple of traces (and re-connect them if you wish to use the drive).

[Slick]

You do point out the obvious

[blakey8]

He didn't know "the obvious" though did he?

[Slick]

also you dont need to reconnect anything! plus hes already cuts to his board! also if he clicked the link he would know the obvious!