My drive is now in vendor mode and this is appearing when trying to write original firmware..

How can i solve this? Thanks

Start over again I've had that when I pull the power lead and did not put back in fast enuff

Make sure that your drive tray is half open, and is in the right spot. Lite on drives are picky as to how far the drive is open.

Slide the tray either way until it works.

hope that helps

What drive are you trying to flash?

If that is the case you'll need the upload the previous bin file and then add in the "firmware tool 32" tab in JF, and then add the LT bin file spoof it and also save it, and the rest is easy, follow as you would when you are ready to put the drive in vendor mode and so forth.