iXtreme LT+ Lite Touch Xbox 360 Drive Firmware Flashing
Results 1 to 2 of 2
Like Tree1Likes
  • 1 Post By paul.86

Thread: Cutting Winbond chip Pins, Kamikaze Alternative?

  1. #1
    A Helping Hand
    Join Date
    Dec 2009
    Posts
    13
    Thanks
    1
    Thanked 0 Times in 0 Posts

    Cutting Winbond chip Pins, Kamikaze Alternative?

    After looking at the kamikaze mod, it's clear to me that two wires (one connecting to each pin) needs to be cut by drilling into the chip etc..

    So it occurred to me, instead of drilling through the chip, why can't you just lift the two pins of the chip or cut them?

    Wouldn't that do essentially the same thing?

  2. #2
    Loyalist
    Join Date
    Jun 2011
    Posts
    255
    Thanks
    1
    Thanked 10 Times in 10 Posts
    no the wire you cut by drilling is the gnd wire to the wp and it goes to the leg witch also acts as gnd to otherparts ov the chip
    Methtical likes this.

Similar Threads

  1. Video For The Kamikaze Slim Winbond Unlock Using A SOLDERING IRON
    By intensify in forum iXtreme LT+ Lite Touch Firmware Slim Support
    Replies: 30
    Last Post: 12-30-2011, 05:43 PM
  2. Kamikaze Winbond update lt+ 1.91 to lt+ 2.0
    By Anthro in forum iXtreme LT+ Lite Touch Firmware Slim Support
    Replies: 10
    Last Post: 11-04-2011, 05:21 AM
  3. Kamikaze Hack Counting Pins
    By defhead in forum iXtreme LT+ Lite Touch Firmware Slim Support
    Replies: 5
    Last Post: 09-08-2011, 07:25 PM
  4. Gecko /Kamikaze Winbond Unlock [GUIDE]
    By Frenzy in forum iXtreme LT+ Lite Touch Firmware Slim Support
    Replies: 10
    Last Post: 08-22-2011, 11:50 PM
  5. Kamikaze winbond unlocking 0401
    By ElTexMexAlex in forum iXtreme LT+ Lite Touch Firmware Slim Support
    Replies: 3
    Last Post: 08-12-2011, 06:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
1e2 Forum